Quick Start Guide (USB Versions) |
|
|
|
Views: 538
|
|
Posted: 31 Jan, 2008
by: DeCracker B.
Updated: 05 May, 2010
by: DeCracker B.
|
|
- Install the GTCO/CalComp TabletWorks CD onto your computer. If you do not have the CD, the drivers can be downloaded from www.GTCO.com.
- Connect your GTCO/CalComp digitizer to the computer using the USB cable.
- Click on the TabletWorks icon. It is usually on the system tray at the bottom right-hand side of your computer screen, and looks similar to:
- This will maximize the TabletWorks program. Configure it similarly to the illustration below by ensuring that a check mark is placed below “Enable” and “TabCon”, but NOT below “Mouse” or “WinTab”. Click on the “Apply” button if necessary, then click on “OK” to minimize the TabletWorks window.
- Install the decDigital digitizing software.
- Launch the decDigital program. If the program is already permanently registered, the digitizer is ready to use.
- If the software is DEMO software or newly-installed software that does not yet have a permanent activation code, the digitizer must be activated each time the software is launched. Open the UTILITIES / TEST DIGITIZER window and click on the CONNECT TO TABLET button. See the illustration below.
|
